How To Replace The Cabin Filter On A 2012 Nissan Sentra

Nissan Sentra Cabin Air Filter Replacement Guide
How to make clean or change the HVAC motel air filter element in a 6th generation B16 2007 to 2012 Nissan Sentra sedan.

Kick Panel By Gas Pedal
Pull Off Plastic Panel
Kick Panel Removed This automotive maintenance tutorial was specifically written to assist owners of the 6th generation "B16" (2007, 2008, 2009, 2010, 2011 & 2012) Nissan Sentra sedan in cleaning or changing the A/C arrangement'southward cabin air filter element.

Owners of other Nissan vehicles with like HVAC blower motor housings such as the Versa, Cube, Altima, Maxima, Leaf, Pathfinder, 370Z, Juke, Rogue, Xterra, Murano and Quest may also find these DIY instructions to exist helpful.

A few compatible replacement filters with their function numbers include the following: Purolator C25864, TYC 800126P, Fram CF10550, Wix 49352, Premium Guard PC5864, Hastings AFC1251, Mann MC 1069, Bosch C3907WS, Pentius PHB5864, Beck Arnley 042-2157 and Mahle LA 396.

No tools are needed to replace the filter. A wet/dry shop vacuum tin can be useful for cleaning and reusing the existing element.

Plastic Friction Fasteners
HVAC Blower Motor Housing
Plastic Filter Admission Cover To admission the cabin air filter, you'll get-go need to remove the plastic kicking panel on the commuter'southward side next to the gas pedal.

Gently pull the kick panel straight off to undo the plastic friction fasteners.

Set the panel aside in a safe place.

Simply to the correct of the accelerator or "gas" pedal, you lot'll run across the rectangular black plastic filter access cover.

Pull Off Retaining Clip
Plastic Clip At Bottom
Remove Filter Admission Panel Pull the retaining clip at the bottom of the filter cover down and to the left to release it.

Swing open the filter comprehend and and then lift the summit off the blower motor housing.

Plastic Tab On Acme
Old Air Filter In Slot
Slide Out Old Filter Set the filter cover aside in a safe place.

Slide the old filter out of the slot.

Bend Past Gas Pedal
Old Filter Removed
Empty Filter Slot You will demand to shrink the filter and bend it a bit forward in order to slide it out past the metal bar and the gas pedal.
Audit Both Sides
Clean With Vacuum
Compress & Re-Insert Inspect both sides of the filter.

If the old filter is relatively make clean, just tap out whatsoever big debris and remove any fine dust with a vacuum.

If the old filter is night grey or blackness and clogged with pollen, dirt, twigs, leaves, insect and hair, it should be replaced with a new chemical element.

I'd recommend using the TYC 800126P cabin air filter since it has the best reviews on Amazon.

Slide In Cabin Filter

New Filter Installed In Slot
Line Upwards Filter Embrace If the new filter has an "Air Flow" arrow, it should be pointed towards the rear of the vehicle.

Compress the pleats of the new motel filter and slide it in to the slot.

Continue sliding in the new filter until it is flush with the opening in the blower motor housing.

Attach Hook Tab On Top
Snap On Clip At Bottom
Filter Comprehend Replaced Line upwardly the filter cover and lower the small hook and tab on the tiptop of the slot.

Swing the filter encompass closed and snap the retaining clip on the lesser in place.

Make sure that the filter encompass is securely in place.

Line Upwardly Friction Fasteners
Push On Kick Panel
Plastic Boot Panel Replaced Line up the friction fasteners on the rear of the kick panel and gently push information technology back in to identify.

Exist sure to tape the filter alter in your vehicle's service records.

For more than, bank check out my other 2007-2012 Nissan Sentra Maintenance & Repair Guides.